Jans Metal Works Jans Metal Works Jans Metal Works Jans Metal Works
Jans Metal Works is a full time service metal fabrication center, that has been providing expert service in the east valley for over 35 years.
4808337305
Welding
Welding Types
TIG Gas tungsten arc welding (GTAW), also known as tungsten inert gas (TIG) welding, GTAW is most commonly used to weld thin sections of stainless steel and light metals such as aluminum, magnesium, and copper alloys. The process grants the operator greater control over the weld than competing procedures such as shielded metal arc welding and gas metal arc welding, allowing for stronger, higher quality welds. However, GTAW is comparatively more complex and difficult to master, and furthermore, it is significantly slower than most other welding techniques.
tigweld
MIG Gas metal arc welding (GMAW), sometimes referred to by its subtypes metal inert gas (MIG) welding or metal active gas (MAG) welding Today,, GMAW is the most common industrial welding process, preferred for its versatility, speed and the relative ease of adapting the process to robotic automation.
mig weld
ARC Arc welding uses a welding power supply to create an electric arc between an electrode and the base material to melt the metals at the welding point. The process of arc welding is widely used because of its low capital and running costs.
arc weld
Sub-ARC Submerged Arc Welding (SAW) is a common arc welding process. SAW is normally operated in the automatic or mechanized mode, however, semi-automatic (hand-held) SAW guns with pressurized or gravity flux feed delivery are available. The process is normally limited to the Flat or Horizontal-Fillet welding positions (although Horizontal Groove position welds have been done with a special arrangement to support the flux).
Plastic Plastic welding is the process of welding plastic parts together. There are several techniques with which this can be accomplished: Hot gas welding, Freehand welding, Plastic welding rod, Speed tip welding, Extrusion welding, Contact welding, Hot plate welding, Ultrasonic welding, Vibration or friction welding, Spin welding, Laser welding, Solvent welding.
Aluminum Welding The weld ability of aluminum alloys varies significantly,, depending on the chemical composition of the alloy used. Aluminum alloys are susceptible to hot cracking, and to combat the problem, welders increase the welding speed to lower the heat input.
Copyright © 2012 Jan's Metal Works.com 480-833-7305
Website Produced by: 44oz Design